LifeCam VX-800 Mount Assembly Guide
 




Tools Needed





Parts List
Note: Some of the parts in some assemblies come packaged in seperate smaller bags because they come with a bracket or other various part. Please review the entire parts list to ensure you have all necessary components. Some kits will have spare bolts, nuts, or screws included.


2 X 1 X 3 X 3 X
1 X 1 X






STEP 1 - Disassembly
 
Unscrew the two back screws to remove the front.
 
Unscrew the base stand screw and pull the base stand off.
 
Unscrew the two PCB mounting screws. Use a screwdriver to push the lock tabs out of the way and gently lift out the PCB.
 
Gently move the PCB all the way out of the housing.






STEP 2 - Attach the Angle Bracket
 
Use Flush Cutting Pliers to snip the plastic post out of the way.
 
It will look like this when you are done. It doesn't have to be perfect, just generally flush with the bottom.
 
Before threading the screw through on this inside it helps to thread it in through the bottom to bore out a hole. Just thread it in a little ways then take back out.

 
Use a 7/64" Hex Key to mount the Angle Bracket to the bottom of the camera as shown.

1 x 1 x
 
Secure the bolt with a 6-32 Steel Nut. If you choose you can use glue or Turbo Lock to further secure everything.

1 x






STEP 3 - Close back up
 
Snap the PCB back into place and screw back in the two mounting screws.
 
Replace the two back screws.






STEP 4 - Attach to C Bracket
 
The mounting brackets will be bolted onto the C Bracket as shown.
 
Use three 2-56 3/8" Hex Head Bolts and 2-56 nuts to mount the brackets as shown. Be sure to mount as shown in the picure with the single hole side of the C bracket on the left.

1 x
 
Mount the Angle Bracket into the slot using a 6-32 x 1/4" Hex Socket Head Bolt as shown.

1 x






FIN!
 
If you are mounting your camera onto the Desktop Robot Turret then click here to return to finishing that guide.